Cat® Tiltrotators for excavators provide 360-degree rotation and 40-degree tilting action side-to-side, allowing the machine to reach more work areas from a single position. The tiltrotator enables the operator to maneuver around posts, rocks, and other obstacles, as well as to more easily reach along ditch edges.
Detailed Equipment Specifications
10 Ton Mini Excavators
Interface Options: Top-Bottom
Pin On (Pin Grabber), Pin Grabber
7 Seconds per 1 Full Rotation
Tilt Angle Range +/-
40 degrees left/right
Maximum Bucket Capacity
Maximum Bucket Width
Optimal Hydraulic Flow
45-75 L/min (12-20 gpm)
Maximum Operating Pressure
Complete 360 Degree Rotation
Provides optimal control of your work tools to provide greater flexibility.
Integrated Central Lubrication System
A single point of entry for grease allows the entire unit to be greased quickly and easily.
TRS8 Positioning System
Upgraded software informs the operator of the attachments position via standard equipped monitoring sensors.
Oil Filled Gearbox
A maintenance free solution that more effectively distributes heat, providing better lubrication than grease.
Heavy Duty Worm Gear
Worm gear box with high rotation torque and self locking ability allows digging in all directions with full power, allowing the gear to accept the maximum machine forces and split the load through the entire TRS construction.
Double Acting Cylinders with Load Hold Valves
Valves sustain holding pressures and prevent cylinders movement under load constraints required by directives.
Visual Verification Indicator
The visual verification indicator allows the operator to visibly confirm, from the cab, that the coupler has successfully locked the attachment into place properly.
Locking Control System (LCS)
LCS incorporates an electronic position sensor integrated into the quick coupler hydraulic cylinder. This sensor provides precise and reliable input to an electronic processor mounted inside the quick coupler. This microprocessor provides digital communication to the Next Generation MHE machine Electronic Control Module (ECM) by way of an electrical harness. This data is then displayed on the operators display screen, and will provide audible indications when that locking status changes.
Only compatible with the following Next Gen machines and serial numbers: 307.5 - S/N GW7 1 & Up 308 - S/N GG8 1 & Up 308 - S/N GW8 1 & Up 308.5 - S/N GZ8 1 & Up 309 - S/N GG9 1 & Up 309 - S/N GW9 1 & Up 310 - S/N GWT 1 & Up