Air Inlet System

• Dual turbochargers

• Corrosion-resistant aftercooler core

• Air cleaners — single or dual element

Exhaust System

• Dry exhaust manifolds with thermo-laminated heat shields

• Dual turbochargers with water-cooled bearings and thermo-laminated heat shields

• Vertical exhaust outlet

• Flange and exhaust expanders

Cooling System

• Separate-circuit-aftercooler (SCAC) and jacket water (JW) circuit cooling system

• Gear-driven centrifugal pumps, one for each circuit

• SCAC electronic thermostat, outlet-controlled with aftercooler inlet temperature sensing

• JW electronic thermostat, outlet-controlled with outlet temperature sensing

• Engine oil cooler in JW circuit

Fuel System

• Cat common rail high-pressure fuel system with electronically controlled unit injectors

• Duplex primary fuel filter with water separator

• Duplex secondary/tertiary fuel filters

• Electric fuel priming pump

• Gear-driven low pressure transfer pump

• Gear-driven high pressure transfer pump

• Double-walled high pressure fuel lines

• Fuel pressure, temperature, and leak detection sensors

Lubrication System

• Engine-driven, gear-type oil pump

• Integral lube oil cooler

• Front-mounted oil drain lines and valve

• Oil sampling valve

• Filler and dipstick

• Four-canister simplex oil filter

• Prelube pump — electric, air, or custom

• Fumes disposal with crankcase breathers

• Crankcase explosion relief valves

Engine Control and Protection

• Dual ADEM A4 engine control unit (ECU) for redundancy

• Software monitors engine parameters and performs alarm, derate, and shutdown functions

• Rigid wiring harness

• Marine Power Display 3.0 (MPD 3.0)

Mounting

Generator

• Kato brushless permanent magnet 6P6.6-3200 HR

• 2-bearing, close-coupled arrangement

• 60 Hz, 600V, 0.7 PF

• UL/CSA listed, IP23

Flywheel and Coupling

• Flywheel housing, SAE No. 00

• Flywheel, SAE No. 00

• ABS certified, non-certified, or custom-coupling and coupling mounting

• Free-standing or close-coupled generator set arrangements

Starting System

• Turbine air starter or

• Dual electric starting motors or

• Air and electric starting motors (redundant)

General

• Power distribution box — 24V or custom

• 20A battery charger

• Cat yellow paint

• Offshore oil field sub-base

• Integral spring isolators with limit stop

• Lift provisions on base

• Oil drain extension

• Engine length drip pan with drain

• Torsional dampened driveline couplings

Air Inlet System

Cooling System

• 9 kW, 240V, 60 hz jacket water heater

• Custom jacket water heater

Fuel System

Engine Control and Protection

• Cat Alarm and Protection System

• Communication module PL1000T/E

• Direct-rack control

• Thermocouples

• Metal particle detector

• SOLAS spray shielding

Mounting

Generator

General

• TVA report

• Special tests

• Project-specific installation drawings

• P&ID-electrical drawings

• Spare parts kit

• Barring group

• Engine lifting group

• Custom generators and radiators