THIS IS MY SELECT
DE605 GC (50 Hz) Generator Set
Maximum Rating
605 kVA
Minimum Rating
605 kVA
Emissions/Fuel Strategy
Non Regulated
SPECIFICATIONS
Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Engine Specifications
Engine Model
C15 In-line 6, 4-cycle diesel
Bore
5.4 in
137 mm
Stroke
6.8 in
171 mm
Displacement
928 in³
15.2 l
Compression Ratio
16.1:1
Aspiration
Turbocharged Air-to-Air Aftercooled
Fuel System
EUI
Governor Type
Adem™A4
Generator Set Dimensions
Length - Maximum
131 in
3,328 mm
Width - Maximum
60.6 in
1,540 mm
Height - Maximum
86.1 in
2,187 mm
Dry Weight - Genset (maximum)
8,120 lb
3,683 kg
Generator Set Specifications
Maximum Rating
605 kVA
Minimum Rating
605 kVA
Emissions/Fuel Strategy
Non Regulated
Voltage
380 to 415 Volts
Frequency
50 Hz
Speed
1500 rpm
Duty Cycle
Standby
- Engine
- Cat® C15 Inline 6 Cylinder, 4 Stroke Diesel
- Control Panels
- GCCP 1.1
- Air Inlet
- Air Cleaner
- Governor
- Mechanical Governor
- Alternator
- A Frame Standard Alternator
- Cooling
- Package mounted radiator
- Fuel Storage
- Single Wall 8 Hour Tank
- Cooling System
- Caterpillar Extended Life Coolant
- Radiator and cooling fan with guards
- Fan drive, battery charging alternator drive
- Electrical Options
- 3 Pole Circuit Breaker
- Neutral Earth Link
- 24 Volt battery with rack and cables
- Fuel
- Secondary fuel filter
- Fuel priming pump
- Primary fuel filter with integral water separator
- Air inlet system
- Air cleaner; light duty with disposable element
- Generator
- IP23 Protection
- Matched to the performance and output characteristics of Cat engines
- Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
- Lube system
- Lubricating oil
- Oil drain line with valve
- Mounting system
- Captive linear vibration isolators
- Lifting provision and drag points
- General
- Engine and alternator pre paint, Caterpillar yellow
- Engine and alternator pre paint, Caterpillar yellow
- Power Termination
- Bus Bar
- Generator and Attachments
- Power center, IP22
- Segregated low voltage (AC/DC) wiring panel
- Mandatory Option circuit breaker, IEC, 3 pole, mounted in power centre
- Mounting
- Rubber vibration isolators
- Governing System
- Cat Electronic Governor (ADEM A4).
- Lube System
- Oil cooler
- Oil drain valves
- Mounting System
- Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
- Exhaust
- Industrial, Residential, Critical Mufflers
- Control panel
- Speed and Voltage Adjust Potentiometers
- PLG 4G/3G/Ethernet
- Annunciator
- Emergency E-Stop
- Enclosure
- Cat GC Enclosure
- Generator
- Anti-condensation heater
- Excitation: [ ] Permanent Magnet Excited (PM) [ ] Internally Excited (IE)
- Oversize and premium generators
- Electrical Options
- 4 Pole circuit breaker
- Auxiliary Contacts
- Pad-lockable circuit breaker
- Battery Charger
- Wet Battery
- Power Termination
- Circuit breakers, IEC compliant
- Circuit breakers, UL listed
- Alternator
- Space Heater
- AVR
- Fuel System
- Dual Wall 8Hr Fuel Tank
- Single Wall 8Hr Fuel Tank with Spill Containment
- Low Fuel Level Shutdown
- Low and High Fuel Level Alarms
- Manual fuel transfer pump
- Fuel transfer system controls
- Dual wall fuel tank base
- Generator and Attachments
- Oversize A frame generator
- LC frame CIP generator
- Permanent magnet generator
- Space heaters
- Ingress protection
- LC frame generator
- A frame generator - IP21 Protection
- CIP a frame generator
- Oversize LC frame generator
- Starting/Charging
- Charging alternator
- Jacket water heater
- Battery chargers
- Oversize batteries
- Heavy-duty starting system
- 24 Volt battery with rack and cables
- Air inlet system
- Single Stage Air Filter
- Dual Element Air Filter
- Certifications
- EU certificate of conformance
- EAC certification
- General
- Automatic transfer switches (ATS)
- EEC Declaration of Conformity
- Integral & sub-base UL listed dual wall fuel tanks
- Single or dual wall sub-base fuel tanks
- Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
- CSA Certification
- UL 2200 package
- The following options are based on regional and product configuration:
- Single or dual wall integral fuel tanks
- EU Certificate of Conformance (CE)
- Sound attenuated, weather protective or high ambient weather protective enclosure
- Narrow, Wide or Skid Base
- Extended service coverage
- 3, 4, 5 and 10 Years
- Enclosures
- High ambient sound attenuated enclosures
- Exhaust System
- Industrial Silencer
- 10 dBA Attenuation silencer
- Manifold and turbocharger guard
- End in / End out mufflers - 10, 25 and 35 dBA attenuation
- Flexible exhaust fittings
- 6 and 8 inch elbow kit
- 6 and 8 inch flange GP
- Engine mounted muffler
- Lube System
- Manual sump pump
- Mounting System
- Narrow skid base - replaces standard fuel tank base
- Special Test / Reports
- PGS Test report @ 1.0 power factor
- PGS Test report @ 0.8 power factor
- Starting / Charging System
- 5 Amp single battery charger
- Battery disconnect switch
- Jacket water heater
Similar Models
WHY CHOOSE EMPIRE
-
Machines built tough and ready to run in rugged applications
-
Trusted advisors to help you find and maximize your equipment
-
Wide inventory of rental equipment that lets you try before you buy
-
Full service and support to ensure performance and longevity