THIS IS MY SELECT

High Performance Propulsion and Maneuvering Solutions

C12 High Performance Marine Propulsion Engine

Power Range

578-609 mhp (570-600 bhp)

Speed Range

2300 rpm

Emissions

IMO I

SPECIFICATIONS

Cat® C12 Diesel Marine Propulsion Engines, with ratings of 578-609 mhp (570-600 bhp) at 2300 rpm, meet IMO I emission standards. The C12 takes full advantage of the electronically controlled unit injection fuel system, resulting in an environmentally friendly engine with outstanding performance and fuel economy. There is also a wide range of optional equipment available to meet the needs of your marine commercial or pleasure craft application.

    Dimensions & Weights

    Dry Weight

    2,588 lb

    Width

    38.1 in

    Length

    62 in

    Height

    39.5 in

    Engine

    Speed Range

    2300 rpm

    Emissions

    IMO I

    Aspiration

    TA

    Bore

    5.1 in

    Stroke

    5.9 in

    Displacement

    732 in³

    Rotation from Flywheel End

    Counterclockwise

    Configuration

    In-line 6, 4-Stroke-Cycle Diesel

    Ratings

    Power Range

    578-609 mhp (570-600 bhp)

    • Air Inlet System
      • Aftercooler - sea water; corrosion resistant, Air Cleaner/Fumes Disposal (closed system), Turbocharger, Jacket Water Cooled
    • Control System
      • Electronic governing, Cold mode start strategy, Power compensation for fuel temperature, Programmable low idle, Electronic diagnostics and fault logging, Engine and transmission monitoring (speed, temperature, pressure), Fuel/air ratio control, Emergency stop switch (A&B ratings only)
    • Cooling System
      • Thermostat and housing, Jacket water pump; gear driven, Sea water pump; rubber impeller; self-priming; gear-driven, Integral heat exhanger/expansion tank; removable tube bundle; replaceable copper-nickel tubes, Keel cooling - combined circuit (includes pipe thread flange kit)
    • Exhaust System
      • Watercooled Manifold & Turbocharger
    • Flywheels & Flywheel Housings
      • Flywheel; SAE No. 1; 113 teeth, Flywheel housing; SAE No. 1 (10 degree slant pad), SAE standard rotation
    • Fuel System
      • Fuel filer; RH service on Port; LH service on Starboard, Fuel transfer pump, Fuel priming pump, Flexible fuel lines
    • Instrumentation
      • Service meter, electric
    • Lube System
      • Crankcase breather, Oil cooler, Oil filter; spin-on; RH service on Port; LH service on Starboard, Oil filler, Dipstick; RH service on Port; LH service on Starboard, Oil pump; gear driven
    • Mounting System
      • Front support
    • Power Take-Offs
      • Hydraulic pump drive; SAE A; 11 tooth spline, 57 ft-lbs max torque; counterclockwise as viewed from the rear of hte engine looking into the pump drive and turns 1.41 x engine speed, Crankshaft pulley; 345 mm (13.6 in) single groove; 15.88 mm (.63in) width
    • Protection System
      • Shutdown; electronic; 12 or 24 volt; energized to run
    • General
      • Vibration damper, Lifting eyes, RH or LH service options, Literature, Variable engine wiring, Upper rear-facing customer wiring connector and ECAP connection, Electronic installation kit (connectors, pins, sockets)

    • Air Inlet System
      • Low Profile Air Inlet Line, Shield (Air Inlet Line)
    • Charging System
      • Charging Alternators, Voltmeter Guages, Voltmeter Guage Mounting, Alternator Mounting Group
    • Cooling System
      • Sea Water Pump, Coolant Recovery Tank, Flange Kit
    • Exhaust System
      • Flexible Fitting, Elbow, Dry Elbow, Watercooled Elbow, Exhaust Connection, Exhaust Outlet Pipe, EXH Outlet Flange, Rain Cap, Muffler
    • Fuel System
      • Fuel Cooler, Fuel Connections, Primary Fuel Filter, Primary Fuel/Water Separator
    • Instrumentation
      • OEM Wiring Harness, Engine to Engine Harness, Digital Tachometer, Tachometer Mounting, Magnetic Pickup, RH 4 Hole Instrument Panel, LH 4 Hole Instrument, Marine Power Display System, Marine Power Display Unit (for additional monitoring stations), Marine Power Display Bracket, Wiring Group, Transmission Sensors
    • Lube System
      • Manual sump pump, Transmission oil cooler
    • Mounting System
      • Vibration Isolators
    • Power Take-Offs
      • Crankshaft Pulley, Front Stub Shaft, Front Stub Shaft & Pulley
    • Starting System
      • Air Pressure Regulator, Air Start Silencer, Start Switch, Jacket Water Heater, Battery sets (24 volt - dry)
    • General
      • Wiring Harness Removal, Belt Guard - Alternator, Belt Guard - Alternator Pulley, Filter Cover Kit
    • Packing
      • Overseas Preservation, Engine Protective Cover, Storage Preservation, Export Packing

    Similar Models

    WHY CHOOSE EMPIRE

    • Machines built tough and ready to run in rugged applications

    • Trusted advisors to help you find and maximize your equipment

    • Wide inventory of rental equipment that lets you try before you buy

    • Full service and support to ensure performance and longevity

    YOU MIGHT ALSO BE INTERESTED IN