THIS IS MY SELECT

Diesel Generator Sets

3512C Generator Set

Maximum Rating

1750 ekW

Minimum Rating

1600 ekW

Emissions/Fuel Strategy

U.S. EPA Cert., Tier 2
Browse Rental Power Systems Search Used Power Systems
REQUEST A QUOTE
Download Product Brochure
    Download Product Brochure
    Document 1

    View Current Deals

    SPECIFICATIONS

    Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

      FULL SPECIFICATIONS

      Engine Specifications

      Engine Model

      3512C ATAAC, V-12, 4-Stroke Water-Cooled Diesel

      Bore

      6.69 in

      Stroke

      8.46 in

      Displacement

      3,574 in³

      Compression Ratio

      14.7:1

      Aspiration

      TA

      Fuel System

      Electronic unit injection

      Governor Type

      ADEM™ A3

      Generator Set Dimensions

      Length - Maximum

      262.9 in

      Width - Maximum

      89.8 in

      Height - Maximum

      110 in

      Dry Weight - Genset (maximum)

      32,660 lb

      Generator Set Specifications

      Maximum Rating

      1750 ekW

      Minimum Rating

      1600 ekW

      Emissions/Fuel Strategy

      U.S. EPA Cert., Tier 2

      Voltage

      380 to 13800 Volts

      Frequency

      60 Hz

      Speed

      1800 rpm

      Duty Cycle

      Standby, Mission Critical

      Standby Rating

      1750 ekW

      Prime Power Rating

      1600 ekW
      STANDARD EQUIPMENT

      • Air Inlet System
        • Air cleaner; single element canister type with service indicator
      • Cooling
        • Package mounted radiator
      • Exhaust
        • Exhaust flange outlet
      • Fuel
        • Primary fuel filter with integral water separator
        • Fuel priming pump
        • Secondary fuel filters
      • Generator
        • Matched to the performance and output characteristics of Cat engines
        • IP23 Protection
      • Power Termination
        • Busbar
      • Control Panel
        • EMCP 4 Genset controller
      • Control System
        • Generator set packages include Caterpillar's voltage
          regulator (IVR). IVR includes reactive droop capability, 3-phase voltage sensing, KVAR / PF modes, RFI suppression, min/max exciter. Limiter and exciter diode monitor
        • Emergency stop pushbutton
        • Oil pressure (psi, kPa or bar)
        • 1 Programmable digital outputs
        • Accessory module data link
        • 4 Programmable relay outputs (Form A)
        • kVAr-hr (total)
        • Reverse power (kW) (32)
        • kVAr (per phase, average & percent)
        • Amps (per phase & average)
        • Over/under frequency (81 o/u)
        • EMCP 4.2B
        • PLC functionality
        • 1 Programmable relay outputs (Form C)
        • Programmable protective relaying functions:
        • RPM
        • Frequency (Hz)
        • Low coolant level
        • Number of I/O varies on options selected
        • Lamp test
        • kVA (per phase, average & percent)
        • Emergency stop
        • kW (per phase, average & percent)
        • Engine cool-down timer
        • Speed adjust
        • Generator phase sequence
        • Over/under voltage (27/59)
        • Warning/shutdown with common LED indication of shutdowns for:
        • Customer data link (Modbus RTU)
        • Volts (L-L & L-N)
        • High coolant temperature
        • Engine cycle crank
        • True RMS AC metering, 3-phase, +/-2% accuracy
        • Low coolant temperature
        • Low oil pressure
        • Cat connect
        • Digital indication for:
        • Communications
        • Environmental sealed front face
        • Reverse reactive power (kVAr) (32RV)
        • 24 Volt DC operation
        • Power factor (per phase & average)
        • Overspeed
        • Auto/start/stop control
        • Load histogram feature
        • Controls:
        • Failure to start (overcrank)
        • Customizable screens
        • kW-hr (total)
        • Text alarm/event descriptions
        • Alarm acknowledge
        • Overcurrent (50/51)
        • Generator mounted - rear facing
        • Coolant temperature
        • DC volts
      • Governing System
        • ADEM III
      • Cooling System
        • SCAC
        • Fan and belt guards
        • Caterpillar extended life coolant (Not included with packages without radiator, installed SF44CTS
        • Coolant level sensors (Not included with packages without radiator)
        • Radiator fan and fan drive
        • Coolant drain line with valve
      • Exhaust System
        • Flanged faced outlet(s)
        • Dry exhaust manifold
      • Fuel System
        • Secondary fuel filters
        • Fuel priming pump
        • Fuel cooler; not included with packages without radiator
        • Flexible fuel lines - shipped loose
      • Generators and Attachments
        • Random wound
        • Permanent magnet excitation (PMG)
        • High voltage
        • Six lead
        • NEMA standard hole pattern
        • NEMA Class H insulation system, Class H temperature rise at 40C ambient
          (125C prime / 150C standby)
        • NEMA Class H insulation system, Class H temperature rise at 40C ambient
          (125C prime/150C standby)
        • Class H insulation, Class F temperature rise at 40C ambient
          (105C prime/130C standby)
        • NEMA standard hole pattern
        • Winding temperature detectors
        • NEMA standard hole pattern
        • Internal excitation (IE)
        • Form wound
        • 3 Phase brushless, Salient pole
        • Busbar connections, right side extension box, bottom cable entry
        • Low voltage:
        • Busbar connections, top center mounted, top cable entry
        • Medium voltage:
      • Literature
        • English
      • Lube System
        • Oil drain lines and valve
        • Lubricating oil
        • Oil filter, filler and dipstick
        • Fumes disposal
        • Gear type lube oil pump
        • Integral lube Oil cooler
      • Mounting System
        • Rubber anti-vibration mounts - shipped loose
      • Starting / Charging System
        • Battery and battery rack w/cables
        • 45 Amp Charging alternator
        • 24 Volt electric starting motor
        • Battery disconnect switch
      • General
        • Paint - Caterpillar yellow except rails and radiators gloss black
        • SAE standard rotation
        • Right hand servicing
        • Flywheel and Flywheel housing-SAE No. 00
        • Paint - Caterpillar yellow with high gloss black rails & radiator

      OPTIONAL EQUIPMENT

      • Control Panels
        • Digital I/O module
        • EMCP 4.3, EMCP 4.4
        • Load share module
        • Remote monitoring software
        • Generator temperature monitoring & protection
      • Exhaust
        • Exhaust mufflers
      • Air Inlet System
        • Heavy duty air cleaner
        • Single element filter
      • Generator
        • Permanent magnet excitation (PMG)
        • Anti-condensation heater
        • Internal excitation (IE)
        • Oversize and premium generators
      • Power Termination
        • Circuit breakers, IEC compliant
        • Circuit breakers, UL listed
      • Cooling System
        • Standard installed radiators
        • Standard installed ATAAC radiators
        • Optional installed ATAAC radiators
        • Water level switch gauges
        • Coolant
        • Optional installed radiators
      • Exhaust System
        • Flanges
        • Flange and exhaust expanders
        • Flexible fittings
        • Elbows
        • Y Adapters
        • Mufflers
      • Fuel System
        • Primary fuel filter
      • Starting/Charging
        • Heavy duty starting system
        • Charging alternator
        • Battery chargers
        • Oversize batteries
        • Air starting motor with control and silencer
        • Jacket water heater
      • Generators and Attachments
        • 1400, 1600, 2700 Frames
        • Space heater
        • Generator conversion from IE to PM
        • Differential current transformers (DCT) 15 kV class
        • RW, IE, 6 Leads, Pitch 0.6667
        • Generator air cleaner
        • Low voltage: 380,440 / 480 Volts, 3 Phase, 1800 rpm
        • Differential current transformers (DCT) 8.7 kV class
      • Instrumentation
        • Wiring GP W/O cyl sensors
        • Pyrometer and thermocouples
      • Lube System
        • Oil drains
        • Lubrication oil in standard sump
        • Oil level regulator
        • Prelube pumps
      • General
        • US aid emblem
        • The following options are based on regional and product configuration:
        • Automatic transfer switches (ATS)
        • EU Certificate of Conformance (CE)
        • CSA Certification
        • Integral & sub-base UL listed dual wall fuel tanks
        • EEC Declaration of Conformity
        • UL 2200 package
        • Integral & sub-base fuel tanks
        • Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
        • Enclosures: Sound attenuated, weather protective
      • Crankcase Protection
        • Crankcase ventilation system
        • No explosion relief valves
        • No crankcase explosion relief valves
        • Explosion relief valves
      • Mounting System
        • Spring type vibration isolators
        • IBC vibration isolators
        • Puck style low efficiency isolators
      • Mounting
        • IBC isolators
        • Rubber anti-vibration mounts
        • Spring type vibration isolators
      • Power Connections
        • 1600 ,2000, 2500, 3000, 4000 Amp, 3 Pole, UL-100% rated Circuit breakers
        • Grounding groups
        • Neutral ground connections
        • Right side power connections
        • Rear power connections
        • Left side power connections
        • Six lead, six terminal option
        • 2000, 2500, 3200 Amp, 3 Pole, IEC rated Circuit breakers
        • Center post busbars
        • 2000, 2500 Amp, 4 Pole, IEC rated Circuit breakers
        • Cable entry - right side
      • Special Tests / Reports
        • Fuel consumption test
        • Generator test report
        • IBC seismic Certification
        • PGS Test report @ 1.0 power factor
        • Standard engine test charge
        • CSA Certification
        • Generator fuel consumption test
        • Torsional vibration analysis
        • PGS Test report @ 0.8 power factor
      • Starting / Charging System
        • 24 Volt battery set - Dry
        • Air pressure regulator
        • 10 Amp Battery charger
        • Air starting motor
        • 35 Amp Battery charger
        • Jacket water heaters
        • Starter cover
        • Engine barring device
        • Batteries, racks and cables:
        • Electric starting motors

      Related Attachments

      Similar Models

      WHY CHOOSE EMPIRE

      • Machines built tough and ready to run in rugged applications

      • Trusted advisors to help you find and maximize your equipment

      • Wide inventory of rental equipment that lets you try before you buy

      • Full service and support to ensure performance and longevity

      YOU MIGHT ALSO BE INTERESTED IN

      VALUE AGREEMENTS

      SERVICE

      TRAINING