THIS IS MY SELECT
C15 Generator Set
Maximum Rating
550 kVA
Minimum Rating
365 kVA
Emissions/Fuel Strategy
Tier 2 or Tier 3
SPECIFICATIONS
Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Engine Specifications
Engine Model
C15 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Bore
5.4 in
137.2 mm
Stroke
6.75 in
171.4 mm
Displacement
927.56 in³
15.2 l
Compression Ratio
16.1:1
Aspiration
Air to Air Aftercooled
Fuel System
MEUI
Governor Type
Adem™A4
Generator Set Dimensions
Length - Maximum
150.8 in
3,830 mm
Width - Maximum
58.3 in
1,481 mm
Height - Maximum
86.3 in
2,193 mm
Generator Set Specifications
Maximum Rating
550 kVA
Minimum Rating
365 kVA
Emissions/Fuel Strategy
Tier 2 or Tier 3
Voltage
208 to 600 Volts
Frequency
50 Hz
Speed
1500 rpm
Duty Cycle
Standby, Prime
- Air System
- Turbocharger
- Aftercooler core
- Air cleaner - Non canister disposable paper filter
- Air Inlet
- Air cleaner
- Control Panel
- GCCP 1.3
- Cooling
- Package mounted radiator
- Cooling System
- Caterpillar extended life coolant
- Radiator and cooling fan with guard
- Fan drive, battery charging alternator drive
- Coolant drain line with valve
- Exhaust
- Base, formed steel with single wall integral 8-hour fuel tank
- Standard open set fuel tank/base supplied
- Fuel
- Primary fuel filter with integral water separator
- Secondary fuel filters
- Fuel priming pump
- Fuel System
- Engine fuel transfer pump
- Primary fuel filter w/integral water separator and secondary filter
- Fuel priming pump
- Flexible fuel lines
- Fuel cooler
- Generator
- Matched to the performance and output characteristics of Cat engines
- IP23 Protection
- Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
- Power Termination
- Busbar
- Generator and Attachments
- Mandatory option circuit breaker, IEC, 3 pole, mounted in power centre
- Optional LC Frame generator - IP23 Protection
- Segregated low voltage (AC/DC) wiring panel
- Integrated voltage regulator (IVR)
- Power center, IP22
- Mounting
- Rubber vibration isolators
- Governing System
- Cat electronic governor (ADEM A4).
- Lube System
- Oil cooler
- Oil drain valves
- Mounting System
- Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
- Starting/Charging
- 24 Volt battery with rack and cables
- General
- Engine and alternator pre paint, Caterpillar yellow
- Air Inlet System
- Single element air cleaner
- Dual element air cleaner
- Exhaust
- Industrial, residential, critical mufflers
- Certifications
- EU Certificate of Conformance (CE)
- Global certification for CIS
- Generator
- Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
- Oversize and premium generators
- Anti-condensation heater
- Power Termination
- Circuit breakers, UL listed
- Circuit breakers, IEC compliant
- Circuit breakers
- Shunt trip for IEC circuit breaker
- 4 Pole (IEC-100% rated) Circuit breakers - Package mounted
- Auxiliary contacts, circuit breaker
- 3 Pole (IEC-100% rated) Circuit breakers - Package mounted
- 3 Pole (IEC-100% rated) Circuit breakers - Motorised
- Power terminal strip
- 4 Pole (IEC-100% rated) Circuit breakers - Motorised
- Padlockable circuit breaker device
- Generator and Attachments
- Permanent magnet excitation (PMG) generator
- LC frame CIP generator
- Oversize LC frame generator
- Space heaters
- CIP A Frame generator
- Oversize A Frame generator
- Ingress protection
- A Frame generator - IP21 Protection
- LC frame generator
- Control Panels
- Fuel level sensor
- Volt free contacts
- Oil temperature displays
- Local annunciator
- GCCP 1.4
- Local alarm horn
- Remote annunciator module
- Starting/Charging
- Oversize batteries
- Battery chargers
- Jacket water heater
- Heavy duty starting system
- Charging alternator
- Cooling System
- Low coolant temperature alarm
- Stone guards
- Radiator duct flange
- General
- Narrow, wide or skid base
- Single or dual wall integral fuel tanks
- Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
- The following options are based on regional and product configuration:
- Automatic transfer switches (ATS)
- Integral & sub-base UL listed dual wall fuel tanks
- CSA Certification
- EEC Declaration of Conformity
- Single or dual wall sub-base fuel tanks
- UL 2200 package
- Sound attenuated, weather protective or high ambient weather protective enclosure
- EU Certificate of Conformance (CE)
- Enclosures
- High ambient sound attenuated enclosures
- Sound attenuated enclosures
- Exhaust System
- 6 and 8 inch elbow kit
- Manifold and turbocharger guards
- End in/end out mufflers - 10, 25 and 35 dBA attenuation
- Engine mounted muffler
- 6 and 8 inch flange GP
- Flexible exhaust fittings
- Fuel System
- Fuel transfer system controls
- Manual fuel transfer pump
- Dual wall fuel tank base
- Lube System
- Manual sump pump
- Mounting System
- Narrow skid base - replaces standard fuel tank base
- Special Test / Reports
- PGS Test report @ 1.0 power factor
- PGS Test report @ 0.8 power factor
- Starting / Charging System
- 5 Amp single Battery charger
- Jacket water heater
- Battery disconnect switch
Related Attachments
Similar Models
WHY CHOOSE EMPIRE
-
Machines built tough and ready to run in rugged applications
-
Trusted advisors to help you find and maximize your equipment
-
Wide inventory of rental equipment that lets you try before you buy
-
Full service and support to ensure performance and longevity